Installation

  • Adequate fixing should be provided at no greater than 500mm centers.
  • We recommend an air gap of 6mm adjacent to ovens and other heat sources.
  • Do NOT over tighten handles as it may cause an unsightly dip in the high gloss surface.
  • Ensure that the masking film is cut cleanly. No masking strands should be there as failure to correct the process would make the edge banding process more difficult and time consuming.

Hinge Recommendation:

  • Always test hinge boring tools to ensure a clean cut is achieved.
  • Reliable results will be achieved by drilling or boring through a thin MDF sacrificial block.